First, the cutting width
The cutting width does not greatly affect the cutting quality during normal use. The size of the width data is mainly due to the very fine contours formed within the part, which has a very important influence on it. Therefore, when choosing related machines, these issues must be carefully considered, especially some items, which have strong internal quality requirements.
In addition, this data has a great influence on the internal data of the machine and determines the small inner diameter of the contour. As the thickness of the sheet increases, the width of the cut also increases. When you are producing related products, you have to look at the thickness of this thing to avoid using the wrong related board. Some small knowledge must be prepared in advance, so as not to delay your work efficiency.
Second, texture
Usually high-speed cutting of thick plates is that the molten metal texture will not appear in the cut below the vertical laser beam, but will be ejected at the rear of the laser beam. In this process, the curved lines will be formed on the edge of the cutting place, and the position of the Guobo lines will follow the movement of the laser, and relevant changes will be made continuously. Invisible, and this may affect the quality of cutting. Generally, in order to correct this common problem, it is necessary to reduce the work flow during operation, so that no related lines will be formed. When you work, some products are more picky about texture, so be careful in the operation process.
Third, depression and corrosion
In the cutting process, sometimes inadvertent depression and corrosion will occur, which visually affects the appearance of the product. This is mainly due to cutting errors, which destroy the relevant appearance and even affect the cost of the product. This phenomenon is unavoidable, even with automatic cutting machines.
And that kind of machine needs to be checked every six months to see if there is corrosion. In this process, if there is a problem, the relevant pipeline must be promptly disposed of or replaced. This process is very necessary, and for enterprises, unnecessary losses can also be avoided.
Fourth, the quality of operating staff
In fact, the automatic cutting machine is not suitable for everyone. If a company purchases this machine, it is necessary to train its employees.