In addition to the maintenance of the deburring machine, it is necessary to clean the water and workpiece residues on the work surface of the deburring machine after each use. If the dust on the printed circuit board is not removed, it will easily absorb the moisture and corrosive things in the air over a long period of time, corrode the original small conductive copper skin, and cause machine failure. Always clean up the dust inside the electrical box, such as the dust on the power resistor, the dust on the discharge bridge, especially the dust on the printed circuit board, this will help the heat dissipation effect of the electrical components.
The maintenance of the rotating head of the deburring machine is similar to that of the water pump of the deburring machine. The rotating head also works under high pressure, and its seals need to be replaced regularly. If there is a water leakage and then replaced, it is possible that water has penetrated into the bearing. , The loss is even greater. Maintenance of the water pump of the CNC EDM perforating machine tool. The water pump of the deburring machine is operated under a working pressure of 6Mpa. The curved bearing inside is under very heavy pressure. If the lubricant is not replaced immediately after a period of work, it will cause Very serious consequences. This one is easily overlooked by many deburring machine users, and we should pay attention to it. Because the water pump is a very important component in the deburring machine, if something goes wrong with this component, it will affect the use of the entire machine tool.