The maintenance of the rotating head of the deburring machine is similar to that of the water pump of the deburring machine. The rotating head also works under high pressure, and its seals need to be replaced regularly. If there is a water leakage and then replaced, it is possible that water has penetrated into the bearing. , The loss is even greater.
Because the water pump is a very important component in the deburring machine, if something goes wrong with this component, it will affect the use of the entire machine tool. Maintenance of the deburring machine water pump. The deburring machine water pump is operated at a working pressure of 7Mpa. The curved bearing inside is under very heavy pressure. If the lubricant is not replaced immediately after a period of work, it will cause serious problems. as a result of. This one is easily overlooked by many deburring machine users, and we should pay attention to it.
The general maintenance principle of deburring machine In addition to the maintenance of the deburring machine, the water and workpiece residues on the work surface of the deburring machine should be cleaned after each use. Always clean up the dust inside the electrical box, such as the dust on the power resistor, the dust on the discharge bridge, especially the dust on the printed circuit board, this is conducive to the heat dissipation effect of the electrical components. If the dust on the printed circuit board is not removed, it will easily absorb moisture and corrosive things in the air over a long period of time, corrode the original small conductive copper skin, and cause the machine tool to malfunction.