1. How to deal with machine jam
When the cutting machine is in use, it is very likely that the material will not move forward and the equipment will get stuck. Don't panic in this situation, let alone pull it manually. Be sure to turn off the power of the equipment in time, and then disassemble the parts that are stuck in the material that are currently accessible, and reassemble and install. Usually, there is a corresponding processing method on the operating instructions of the equipment, you can refer to it. For equipment like this in the industrial field, some staff must be familiar with the instructions and understand the initial purchase, and they can solve this problem by themselves.
2. Clean the fuel tank and filter parts
This is true for any industrial equipment. After the equipment is used for about 2 months, the fuel tank and filter components should be cleaned by themselves to avoid the accumulation of heavy oil that is difficult to clean. And these two parts should be cleaned frequently, so as not to affect the integrity of the cutting materials, etc., and a lot of practice has proved that this is an important cause of damage to the mechanical equipment.
3. Check the hydraulic pump
The hydraulic pump of cutting equipment is very important and must be cleaned regularly. At the same time, it is also to check whether there is a problem with the seal of the hydraulic pump, or damage and oil leakage. If such a problem is found, it must be replaced in time. Sloppy and can't delay.
4. Regularly check the operation status of the equipment
After the cutting equipment has been used for a period of time, it is extremely correct to regularly check the operating conditions of the equipment. The direction of the inspection is mainly around the parts. Judging from the operating sound and speed of the equipment, check each part one by one to confirm whether there are related problems one by one. Once it is found to be processed immediately, industrial equipment is like this. It is easy to fail, and problems will affect production efficiency. During downtime, you should check carefully to avoid affecting processing and production.